Installing The Optional Transport Wheels - Toro 04042 Operator's Manual

1
2
3
4
Figure 16
1. Sensor light (on top)
2. Jam nuts
3. EZ-Turn sensor
4. Roller
3. Tighten the jam nuts to secure the sensor.
4. Place a 3.8 cm (1-1/2 inches) block under the front
cutting unit roller (Figure
5. Loosen the fasteners securing the sensor bracket to
the frame (Figure 16).
6. Turn on the machine; refer to
(page 23).
7. Set the EZ-Turn switch to the On position; refer to
EZ-Turn Switch (page
8. Rotate the sensor bracket toward the target plate until
the light on top of the sensor illuminates
it was already illuminated, rotate it away from the target
plate until it goes out and then reverse direction just
until it illuminates again.
9. Tighten the bracket fasteners.
10. Remove the block from under the roller and place the
machine on the kickstand.
11. Ensure that the target plate does not contact the grass
shield.
Note: If it does, loosen the bracket fasteners and
rotate the switch up just until the target plate is no
longer touching the grass shield.
12. Turn off the machine.
8
7
6
5
G0172357
5. 1-1/2 inches (3.8 cm) block
6. Target plate
7. Bracket fasteners
8. Sensor bracket
16).
Turning on the Machine
18).
(Figure 16). If
7
Installing the Optional
Transport Wheels
Parts needed for this procedure:
Transport wheels (Optional Transport Wheel Kit,
2
Model 04123)
Procedure
1. Push the kickstand down with your foot and pull up
on the handle support until the kickstand has rotated
forward, over center
1
1. Kickstand
2. Press the wheel locking clip toward the center of the
wheel and slide the wheel onto the hex shaft
18).
1. Locking clip
16
(Figure 17).
G017244
Figure 17
Figure 18
(Figure