Table of Contents
Advertisement
1
2
3
4
G017236
Figure 10
1. Battery pack receptacle
2. Locking collar
Figure 11
10. Rotate the locking collar on the harness plug clockwise
until it engages with the battery receptacle and begins
to pull in toward the battery. Continue turning it
another 120 degrees (1/3 of a turn) until it fully seats.
Note: If you cannot mate the battery pack receptacle
with the machine wire harness plug while the battery
pack is installed, you can instead connect the harness
to the battery pack and then install the battery pack.
Remove the main power supply connector (Figure
13) from the battery base. Install the connector to
the battery as described. Install the battery to the
base, threading the attached wiring harness through
the appropriate hole, and then secure the main power
3. Pack to machine wire
harness plug
4. Bolt securing the battery
pack
G017358
supply connector to the battery base using the fasteners
previously removed.
11. Remove the screwdriver holding the battery base in the
up position, and gently lower the battery platform to
the machine frame.
Important: Do not pinch the wiring harness
between the frame and platform.
12. Secure the battery platform to the machine frame with
the tall nut removed in step 4.
13. Tighten the pivot fasteners loosened in step 5.
14. Route the pack to machine wire harness under and
behind the main harness on the left side of the machine
and connect the small, 6 pin connector on the harness
to the matching connector on the main wiring harness
as shown in Figure 12.
2
1. Connector on the main
wiring harness
15. Connect the T-handle connector from the main wiring
harness to the main power supply connector on the
battery base (Figure 13).
14
1
G017235
Figure 12
2. Small connector from the
pack to machine wire
harness
Advertisement
Table of Contents
