Table of Contents
Related Manuals for Toro 21852
Summary of Contents for Toro 21852
- Page 1 Form No. 3440-802 Rev B Flex-Force Power System ™ MAX 52cm Recycler ® Lawn Mower Model No. 21852—Serial No. 400000000 and Up Model No. 21852T—Serial No. 400000000 and Up *3440-802* Register at www.Toro.com. Original Instructions (EN)
- Page 2 It is designed to use lithium-ion battery pack Model 81860 (provided with g000502 Figure 2 Model 21852) and 81850 or 81875; it can also use Safety-alert symbol battery pack Model 81825. These battery packs are designed to be charged only by battery charger Model 81802 (provided with Model 21852) or Model 81805.
-
Page 3: Table Of Contents
Replace any damaged or unreadable labels. Use only the battery pack specified by Toro. Using other accessories and attachments may increase the risk of injury and fire. Plugging the battery charger into an outlet that is not 100 to 240 V can cause a fire or electric shock. - Page 4 Charge the battery pack with only the battery common sense when operating the machine. charger specified by Toro. A charger suitable for Do not use the machine while ill, tired, or under 1 type of battery pack may create a risk of fire the influence of alcohol or drugs.
- Page 5 68°C (154°F) or incinerate the machine. it. Replace the battery pack with a genuine Toro battery pack only; using another type of battery Do not attempt to repair the machine except as pack may cause a fire or explosion.
-
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. Model 81860 decal140-3811 140-3811 1. Warning—read the 4. Cutting/dismember Operator's Manual. - Page 7 decal137-9496 137-9496 1. The battery pack is charging. 3. The battery pack is over or under the appropriate temperature range. 2. The battery pack is fully charged. 4. Battery pack charging fault decal112-8760 112-8760 1. Thrown object hazard—keep bystanders away. 2.
-
Page 8: Setup
Setup Note: The battery pack is not fully charged when it is purchased. Before using the machine for the first time, refer to Charging the Battery Pack (page 17). Mounting the Battery Assembling the Grass Bag Charger (Optional) No Parts Required Parts needed for this procedure: Procedure Mounting hardware (not included) -
Page 9: Unfolding The Handle
Unfolding the Handle No Parts Required Procedure WARNING Unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cable(s) when folding or unfolding the handle. • Ensure that the cable(s) are routed to the outside of the handle. •... -
Page 10: Product Overview
7. Grass bag 3. Handle lock (2) 8. Cutting-height lever (2) 4. Rear deflector 9. Side-discharge chute 5. Battery compartment g292995 Figure 7 1. Battery charger Model 2. Battery pack Model 81860 81802 (included with (included with Model Model 21852) 21852) -
Page 11: Before Operation
Operation Note: Determine the left and right sides of the machine from the normal operating position. Before Operation Installing the Battery Pack Important: Operate the battery pack only in temperatures that are within the appropriate range; refer Specifications (page 10). Make sure that the vents on the battery are clear of any dust and debris. -
Page 12: Adjusting The Cutting Height
Adjusting the Cutting Height WARNING Adjusting the cutting-height levers could bring your hands into contact with a moving blade and result in serious injury. • Shut off the motor, remove the electric-start button, and wait for all moving parts to stop before adjusting the cutting height. -
Page 13: During Operation
During Operation Starting the Machine Ensure that the battery pack is charged and installed in the machine; refer to Installing the Battery Pack (page 11). Insert the electric-start button into the electric starter switch (A of Figure 10). Squeeze the blade-control bar and hold it to the handle (B of Figure 10). -
Page 14: Recycling The Clippings
Recycling the Clippings Your machine comes from the factory ready to recycle the grass and leaf clippings back into the lawn. If the grass bag is on the machine, remove it before recycling the clippings. Refer to Removing the Grass Bag (page 14). -
Page 15: Side-Discharging The Clippings
Side-Discharging the Shutting Off the Machine Clippings Release the blade-control bar (A of Figure 15). Remove the electric-start button from the electric starter (B of Figure 15). Installing the Side-Discharge Remove the battery pack; refer to Removing the Chute Battery Pack from the Machine (page 15). -
Page 16: Operating Tips
• For best performance, install a new Toro blade before the cutting season begins or when necessary. Cutting Grass •... -
Page 17: After Operation
After Operation Green Battery pack is charging blinking Green Battery pack is charged Charging the Battery Pack Battery pack and/or battery charger is over or under the appropriate temperature range Important: The battery pack is not fully charged Battery pack charging fault* when you purchase it. -
Page 18: Folding The Handle
Folding the Handle Storing the Machine in the Vertical-Stow Position WARNING You can store your machine in the vertical position to Folding or unfolding the handle improperly minimize storage space. can damage the cables, causing an unsafe operating condition. WARNING •... -
Page 19: Maintenance
Maintenance Remove the electric-start button and battery pack from the machine before maintaining or cleaning the machine. Use only the manufacturer’s recommended replacement parts and accessories. Inspect and maintain the machine regularly. Have the machine repaired only by an Authorized Service Dealer. -
Page 20: Adjusting The Self-Propel Drive
Do not attempt to destroy or disassemble the battery pack or remove any of its components. Loosen the cable-support nut (Figure 23). Contact your local municipality or your authorized Toro distributor for more information on how to responsibly recycle the battery. g009692 Figure 23 1. -
Page 21: Storage
Storage Important: Store the machine, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page 10). Important: If you are storing the battery pack for the off-season, charge it until 2 or 3 LED indicators turn green on the battery. -
Page 22: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The machine does not start. - Page 23 Problem Possible Cause Corrective Action The LED indicator light on the battery 1. There is an error in the communication 1. Remove the battery pack from the charger is blinking red. between the battery pack and the battery charger, unplug the battery charger.
- Page 24 The Toro Company (“Toro”) respects your privacy. When you purchase our products, we may collect certain personal information about you, either directly from you or through your local Toro company or dealer. Toro uses this information to fulfil contractual obligations - such as to register your warranty, process your warranty claim or to contact you in the event of a product recall - and for legitimate business purposes - such as to gauge customer satisfaction, improve our products or provide you with product information which may be of interest.