Specifications; Attachments/Accessories; Operation; Think Safety First - Toro 04042 Operator's Manual

Specifications

1800 Traction Unit
Width 82.5 cm (32-1/2 inches)
Height 104.8 cm (41–1/4 inches)
Length with basket 152.4 cm (60 inches)
Net Weight (with 11 129.3 kg (285 lb)
blade cutting unit and
grass basket installed)
Width of cut 46 cm (18 inches)
Height of cut 1.5 to 7.5 mm (1/16 to 19/64 inches)
with Micro-Cut bedknife
Clip frequency Adjustable (Refer to Cutting Unit
Operator's Manual)
2100 Traction Unit
Width 90.1 cm (35-1/2 inches)
Height 104.8 cm (41–1/4 inches)
Length with basket
152.4 cm (60 inches)
Net Weight (with 11 132.9 kg (293 lb)
blade cutting unit and
grass basket installed)
Width of cut 53.3 cm (21 inches)
Height of cut 1.5 to 7.5 mm (1/16 to 19/64 inches)
with Micro-Cut bedknife
Clip frequency Adjustable (Refer to Cutting Unit
Operator's Manual)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions and decals
in the safety section. Knowing this information could help
you or bystanders avoid injury.

Adjusting the Handle Height

Note: The machine is shipped with the handle adjusted to
the lowest position. The machine is traditionally operated
with the handle telescoped out to its maximum height.
1. Loosen the 3 carriage bolts and nuts securing each side
of the handle in the handle clamps (Figure 27).
1. Handle clamp
2. Nut
2. Pull up on the handle slowly and evenly on each side
until it is in the desired operating position.
3. Tighten the carriage bolts and nuts to lock the
adjustment.

Adjusting the Handle Angle

1. Remove the hairpin cotters from the handle retainers
on each side of the mower (Figure 28).
21
Figure 27
3. Carriage bolts