Servicing The Traction Interlock Switch; Servicing The Mow Sensor - Toro 04042 Operator's Manual

1
G017425
Figure 37
1. Fuse cover
C. Check the fuse and replace it if it is blown.
Only use Toro fuse number 119-1208 to
replace this fuse. This fuse is specially
designed for the battery pack and other "will
fit" fuses may cause irreversible damage to
the pack.
D. Replace and secure the fuse cover. Torque the
cover screw to 0.34 N-m (3 in-lb).
E. Lower and secure the battery platform.
Servicing the Traction
Interlock Switch
Use the following procedure if the traction interlock switch
needs adjustment or replacement.
1. Turn off the machine and disconnect the battery pack.
2. Remove the control panel.
3. Engage the traction lever.
1. Traction lever
2. Mow sensor flag
4. Loosen the interlock switch mounting fasteners (Figure
38).
5. Place a 0.062 inch (1.6 mm) thick shim between the
traction lever and the interlock switch (Figure 38).
6. Tighten the interlock switch mounting fasteners.
Recheck the gap. The traction lever must not contact
the switch.
7. Engage the traction lever and check the gap. The
normal operating range is between .76–3.05 mm
(.03–.12 inches). With the traction lever engaged, verify
that the switch loses continuity. Replace the switch,
if required.

Servicing the Mow Sensor

Use the following procedure if the mow sensor needs
adjustment or replacement.
1. Turn off the machine and disconnect the battery pack.
2. Remove the control panel.
3. Push the traction lever to the left and engage the
mower.
4. Loosen the mow sensor mounting fasteners (Figure
38).
5. Place a 1.6 mm (0.062 inch) thick shim between the
mow sensor flag and the mow sensor (Figure 38).
6. Tighten the sensor mounting fasteners. Recheck the
gap. The flag must not contact the sensor.
7. Engage the traction lever in mowing mode and verify
that the switch loses continuity. Replace the sensor,
if required.
33
G017298
Figure 38
3. Mow sensor
4. Traction interlock switch