Controls - Toro 04042 Operator's Manual

Controls

5
6
4
3
G017156
2
1
Figure 20
1. EZ-Turn switch
2. Open space for optional
lights
3. Parking brake latch
4. Service brake
5. Operator presence control
EZ-Turn Switch
The EZ-turn switch (Figure 20) enables or disables the
EZ-Turn feature. EZ-Turn is a feature that automatically
slows the machine whenever you raise the cutting unit off of
the ground during mowing. This allows you to make the turns
at the end of each mowing pass at a slower speed. You can
use the switch at any time, even while mowing.
This feature only reduces ground speed when the reel is
engaged and lifted off of the ground. It has no effect on
ground speed when the reel is disengaged. If this feature is
activated while mowing and you turn off the reel, the machine
will speed up. If you are mowing at a slow speed already, the
EZ-Turn feature will not slow the machine on a turn.
Service Brake
The service brake (Figure 21) is located on the left front side
of the handle. Pulling the lever back will apply the service
brake. If you operate the machine with the brake on, it will
move, but with high resistance and power consumption will
increase.
7
8
9
6. Handle
7. InfoCenter LCD display
8. Key switch
9. Speed control
1. Parking brake latch
Parking Brake Latch
Use the parking brake latch (Figure 21) in conjunction with
the service brake. Rotate the parking brake latch toward the
brake handle to hold the service brake in place. Pull the brake
lever to release. The traction control lever will not engage
with the latch engaged.
Operator Presence Control (OPC)
You must engage the operator presence control (Figure 20)
before engaging the traction lever. If you release the OPC
during operation, the traction lever will return to neutral but
the machine will not turn off.
InfoCenter LCD Display
The InfoCenter LCD display shows information about your
machine and battery pack such as the current battery charge,
the speed, diagnostics information, and more (Figure 20).
For more information, refer to Using the InfoCenter LCD
Display (page 25).
Key Switch
The key switch (Figure 20) has three positions: Off, Run, and
Start. With the brake off and the traction drive disengaged,
move the switch to the Start position for a few seconds until
the InfoCenter display lights up, then release it to the Run
position. Turn it to the Off position and remove the key to
turn off the machine.
Speed Control
The speed control (Figure 20 and Figure 22) is located on
the right rear side of the control panel. Rotate the control
18
Figure 21
2. Service brake