Configure The Dip Switches - Patton CopperLink 1314 Quick Start Manual

1.0 Configure the DIP Switches

To use DIP-switch configuration, you must first set the DIP switches to a position other than all OFF or all ON
before powering-up the CopperLink. To configure your CL1314 using the DIP switches, refer to the section enti-
tled "Hardware (DIP-switch) configuration" in the CopperLink Model 1314 User Manual.
The CL1314 comes with one of the following power supply options:
External AC adaptor with detachable power cord
•
External DC power supply with terminal block connector (Model 48V-PSM3)
•
2.1 Models with external AC adaptor
Connect female plug of the AC power cord to the AC adaptor provided.
1.
2. Connect the barrel-type connector of the AC adaptor to the
3. Insert the male plug of the AC power cord into an AC power outlet (100–240 VAC).
2.2 Models with external DC power supply
The 36-60 VDC DC to DC adapter is supplied with the DC version of the CL1314. The black and red leads plug
into a DC source (nominal 48VDC) and the barrel power connector plugs into the barrel power supply jack on the
CL1314. (See figure
To Power
Supply Jack
Barrel power connector
CopperLink Model 1314 Quick Start Guide
2.0 Power up the CL1314
1).
Figure 1.
connector on the CopperLink.
-Vin
+Vin
DC Power Supply
To -48VDC
Source
Black lead (-V)
Red lead (+V)
3