Point-To-Multipoint Bridging Setup Guide - Manual Mode; Point-To-Multipoint Bridging Setup Guide - Auto Mode; Repeater Bridge Configuration; Repeater Bridging Setup Guide - Manual Mode - LevelOne WAB-2000 User Manual

108mbps mesh ap/bridge
Table of Contents

Advertisement

WAB–2000 Wireless Access Point

Point-to-Multipoint Bridging Setup Guide - Manual Mode

Direction
Wireless Bridge — General (Manual Bridging Mode)
Wirelss Mode
Tx Rate
Channel No.
Tx Power
Propagation Distance
Bridging Mode
Signal Strength LED MAC
Spanning Tree Protocol
BSSID
Wireless Bridge — Encryption
Bridging encryption options

Point-to-Multipoint Bridging Setup Guide - Auto Mode

Direction
Wireless Bridge — General (Auto Bridging Mode)
Wirelss Mode
Tx Rate
Channel No.
Tx Power Mode
Propagation Distance
Bridging Mode
SSID
Max Auto Bridges
Bridge Priority
Signal Strength MAC
Wireless Bridge — Encryption
Bridging encryption options
Wireless Bridge — MAC Address Filtering
MAC Address Filtering options
The above recommended setup requires only Bridge 1 to be set in point-to-
multipoint mode. It is possible to set all bridges in point-to-multipoint mode,
in which case , each bridge would have to contain the BSSID for each of the
other bridges and Spanning Tree Protocol must be Enabled.
66
Chapter 4: Wireless Bridge Configuration
Bridge 1
802.11a
AUTO
Same as Bridge 2~n
Auto
< 5 Miles
manual bridging se-
lected
Not Assigned (select
from drop-down list)
Enable (or Disable if no
bridging loop possible)
Add Bridge 2~n MAC
Select appropriate key
type/length and value.
Must be the same key
as Bridge 2~n.
Bridge 1
802.11a
AUTO
Same as Bridge 2~n
Auto
< 5 Miles
Auto bridging selected Auto bridging selected
Must be the same as
Bridge 2~n
40 (range 1-40)
40 (range 1-40)
Enter from list at the
bottom of the screen
Select appropriate
key type/length and
value. Must be same
as Bridge 2.
Select Filter Type: in-
put MAC addresses
Bridge 2 ~ n
802.11a
AUTO
Same as Bridge 1
Auto
< 5 Miles
manual bridging selected
Not Assigned (select from
drop-down list)
Enable (or Disable if no
bridging loop possible)
Add Bridge 1 MAC
Select appropriate key
type/length and value.
Must be the same key as
Bridge 1.
Bridge 2 ~ n
802.11a
AUTO
Same as Bridge 2~n
Auto
< 5 Miles
Must be the same as Bridge 2
40 (range 1-40)
40 (range 1-40)
Enter from list at the bottom
of the screen
Select appropriate key type/
length and value. Must be
same as Bridge 2.
Select Filter Type: input
MAC addresses
29000156-001 A

Advertisement

Table of Contents
loading

Table of Contents