Fujitsu PRIMERGY Econel 50 Service Supplement Manual page 77

SATA Hard Disk Drives
1
Figure 11: Installing the hard disk drive
Ê Push the assembled drive with the rails into the free bay until the EasyClick
rails are locked in position.
Ê Connect the power cable/connector P7, P11 or P12 to the relevant power
connector of the drive. You should read the accompanying documentation
supplied with the drive beforehand.
Ê Connect the SATA cable T26139-Y3928-V101 to the SATA interface of the
SATA drive (the free cables are already connected to the system board and
fixed with cable clips at the housing bottom) (see also figure 12 on page 24).
U41599-J-Z156-1-76
Installing SATA Hard Disk Drive
Options Guide 23