Procedure - Fujitsu PRIMERGY Econel 50 Service Supplement Manual

2

Procedure

V
CAUTION!
The actions described in this manual should only be performed by
service personnel.
Ê Before doing anything else, please take notice of chapter "Safety" on page 7
and following.
Ê Make sure all necessary manuals (see service CD) are available; you may
find it advantageous to print the PDF files. You will definitely need the
Operating Manual and the Options Guide for the server and the Technical
Manual for the system board.
Ê Shut down the server correctly, switch it OFF, pull out the power plug, and
open the server as described in the chapter "Replacement Routines" on
page 13 and following.
Ê Replace the defective component as described in the relevant chapter.
Ê Close the server.
Ê Connect the cables.
Ê Connect the server to the line voltage.
Ê Start the operating system.
Ê If necessary, configure the server as required.
Econel 50
Service Supplement 5