Fujitsu PRIMERGY Econel 50 Service Supplement Manual page 82

Installing a Standard PCI controller
Ê Press the unlocking mechanism (1) in the direction of the arrow and fold out
the locking rail (2). The word „PRESS" is embossed on the unlocking
mechanism.
Ê Remove the PCI slot cover (3).
V
CAUTION!
Keep the slot cover for further use. If the controller is removed again
and not replaced with a new controller, the slot cover has to be
reinstalled to comply with applicable EMC regulations and satisfy
cooling requirements and fire protection measures.
Ê Unpack the new controller, and make the desired settings. You should read
the accompanying documentation supplied with the controller beforehand.
Figure 15: Installing the controller
Ê Install the controller into the PCI slot (1) and press it carefully into the
associated plug-in location on the system board until it engages properly.
Ê Fold the locking rail (2) until it engages.
28
1
Options Guide
Controllers in PCI Slots
2
U41599-J-Z156-1-76