Configuration Procedure - HP 5920 series Configuration Manual

Figure 41 Network diagram
IPv6 multicast router
Switch A
XGE1/0/3
Vlan-int100
1001::1/64

Configuration procedure

Configure the IPv6 address and prefix length for each interface as shown in
1.
shown.)
Enable OSPFv3 on the switches to make sure the network-layer among the switches is
2.
interoperable and the routing information among the switches can be dynamically updated.
(Details not shown.)
Configure a GRE tunnel:
3.
# Create service loopback group 1 on Switch A and specify its service type as Tunnel.
<SwitchA> system-view
[SwitchA] service-loopback group 1 type tunnel
# Disable STP and LLDP on interface Ten-GigabitEthernet 1/0/3 of Switch A, and add the
interface to service loopback group 1. Ten-GigabitEthernet 1/0/3 does not belong to VLAN 100
or VLAN 101.
[SwitchA] interface ten-gigabitethernet 1/0/3
[SwitchA-Ten-GigabitEthernet1/0/3] undo stp enable
[SwitchA-Ten-GigabitEthernet1/0/3] undo lldp enable
[SwitchA-Ten-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchA-Ten-GigabitEthernet1/0/3] quit
# Create interface Tunnel 0 on Switch A and specify the tunnel encapsulation mode as GRE over
IPv6.
[SwitchA] interface tunnel 0 mode gre ipv6
# Configure the IPv6 address for interface Tunnel 0 on Switch A and specify its source and
destination addresses.
[SwitchA-Tunnel0] ipv6 address 5001::1 64
[SwitchA-Tunnel0] source 2001::1
[SwitchA-Tunnel0] destination 3001::2
[SwitchA-Tunnel0] quit
# Create service loopback group 1 on Switch C and specify its service type as Tunnel.
<SwitchC> system-view
[SwitchC] service-loopback group 1 type tunnel
Vlan-int101
Vlan-int101
2001::1/64
2001::2/64
Tunnel0
5001::1/64
Source
1001::100/64
IPv6 unicast router
Switch B
Vlan-int102
3001::1/64
GRE tunnel
Member port of the
service loopback group
122
IPv6 multicast router
Switch C
Vlan-int102
3001::2/64
XGE1/0/3
Vlan-int200
4001::1/64
Tunnel0
5001::2/64
Receiver
4001::100/64
Figure 41. (Details not