IPv6 PIM configuration examples
IPv6 PIM-DM configuration example
Network requirements
VOD streams are sent to receiver hosts in multicast. The receiver groups of different organizations form
stub networks, and one or more receiver hosts exist in each stub network. The entire IPv6 PIM domain is
operating in the dense mode.
Host A and Host C are multicast receivers in two stub networks N1 and N2.
MLDv1 runs between Switch A and N1 and between Switch B, Switch C, and N2.
Figure 53 Network diagram
Device
Switch A
Switch B
Switch C
Configuration procedure
Assign the IPv6 address and prefix length to each interface according to
1.
shown.)
Configure OSPFv3 on the switches in the IPv6 PIM-DM domain to make sure they are interoperable
2.
at the network layer and routing information among the switches is dynamically updated. (Details
not shown.)
Interface
VLAN-interface 100
VLAN-interface 103
VLAN-interface 200
VLAN-interface 101
VLAN-interface 200
VLAN-interface 102
IPv6 address
Device
1001::1/64
Switch D
1002::1/64
2001::1/64
2002::1/64
2001::2/64
3001::1/64
159
Interface
VLAN-interface 300
VLAN-interface 103
VLAN-interface 101
VLAN-interface 102
Figure
IPv6 address
4001::1/64
1002::2/64
2002::2/64
3001::2/64
53. (Details not