Static Port Configuration Example - HP 5920 series Configuration Manual

[RouterA-Ten-GigabitEthernet1/0/2] quit
Configure Switch A:
3.
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign Ten-GigabitEthernet 1/0/1 through Ten-GigabitEthernet 1/0/4 to
the VLAN, and enable MLD snooping and the function of dropping IPv6 unknown multicast data
for the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ten-gigabitethernet 1/0/1 to ten-gigabitethernet 1/0/4
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] mld-snooping drop-unknown
[SwitchA-vlan100] quit
# Configure an IPv6 multicast group filter so that the hosts in VLAN 100 can join only the IPv6
multicast group FF1E::101.
[SwitchA] acl ipv6 number 2001
[SwitchA-acl6-basic-2001] rule permit source ff1e::101 128
[SwitchA-acl6-basic-2001] quit
[SwitchA] mld-snooping
[SwitchA–mld-snooping] group-policy 2001 vlan 100
[SwitchA–mld-snooping] quit
Verifying the configuration
Assume that Host A and Host B want to join the IPv6 multicast groups FF1E::101 and FF1E::202 to
receive the IPv6 multicast data from the IPv6 multicast source.
# Display information about the dynamic MLD snooping forwarding entries in VLAN 100 on Switch A.
[SwitchA] display mld-snooping group vlan 100
Total 1 entries.
VLAN 100: Total 1 entries.
(::, FF1E::101)
Host slots (0 in total):
Host ports (2 in total):
XGE1/0/3
XGE1/0/4
The output shows that Host A and Host B have joined the IPv6 multicast group FF1E::101 (through the
member ports Ten-GigabitEthernet 1/0/4 and Ten-GigabitEthernet 1/0/3 on Switch A, respectively),
but the hosts have failed to join the multicast group FF1E::202.

Static port configuration example

Network requirements
As shown in
Switch C run MLDv1 snooping.
(00:03:23)
(00:04:10)
Figure 38, Router A runs MLDv1 and serves as the MLD querier, and Switch A, Switch B, and
111