Creating The Fasttrak S150 Sx4 Raid Controller Driver Diskette - HP proliant ML110 Operation And Maintenance Manual

7. Install the new backplane:
a. Slide the new backplane into the guides on the rear of the cage and align the
b. Use the four screws you removed earlier (step 6-a) to secure the new backplane.
8. Install the HDD cage back into the chassis:
a. Guide the HDD cage into the chassis opening, with the backplane facing the rear of
b. Use the six Torx screws you removed earlier (step 5-a) to secure the cage to the
c. Reconnect the power, data, and LED cables to the hot-plug cage backplane.
d. Install any hot-plug SATA drives into the cage.
9. Observe the post-installation procedures.

Creating the FastTrak S150 SX4 RAID Controller Driver Diskette

If a Microsoft® Windows OS will be used with the Promise FastTrack S150 SX4 RAID
controller card bundled with the server, the user is required to create a RAID driver diskette
prior to the Windows OS installation. Please follow the steps below:
1. Insert a blank, formatted 3.5" diskette into the floppy drive.
2. Insert the HP ProLiant ML110 Server Startup CD into the CD-ROM drive.
3. On the Startup CD's Welcome page, click drivers on item number 3.
4. Under the "4 port SATA Raid controller" column, click the driver link appropriate for the
Windows OS version to be used.
5. Follow the on-screen instructions to create the RAID driver diskette.
HP ProLiant ML110 Server Operations and Maintenance Guide
mounting holes.
Figure 8-5: Installing the backplane
the chassis, and then push the cage all the way into the chassis.
chassis.
Addendum - SATA Configuration
8-5