HP proliant ML110 Operation And Maintenance Manual page 87

System Diagnostics
POST Messages
These text messages are displayed in normal video (white text on black background). It
shows the details of the error. The following is an example of a POST error message:
In some cases an error message may include recommendations for troubleshooting or require
that you press the Enter (or Return) key to display recommendations. Follow the
instructions on the screen.
The table below is a list of the most common error messages with their corresponding
troubleshooting recommendation. It is recommended that you correct the error before
proceeding, even if the server appears to start successfully.
Table 7-1: POST Error Messages
Error message
Operating system not found
Keyboard error
Mouse error
7-2
Error message 1 of 1:
Keyboard not detected - Keyboard error
CAUTION: Do not remove or replace parts until you have reviewed the items described in the
" Troubleshooting Checklist" section in Chapter 6.
Corrective action
•
Verify that there is no non-bootable floppy present in the FDD.
•
Verify that the priority boot drive has power and that its IDE or SCSI
cable is connected properly.
•
Verify that the desired boot drive has power and its SCSI cable is
connected.
•
Verify that the IDE or SCSI cable is securely plugged into their
respective mainboard connector.
•
Verify that the boot device is enabled in the BIOS Setup Utility.
•
Verify that the boot device has an operating system installed.
If the problem persists, contact your HP Customer Support provider.
Verify that the keyboard cable is securely connected to the keyboard port
(not the mouse port) on the rear panel of the server.
If the problem persists, replace the keyboard or contact your HP Customer
Support provider.
Verify the mouse cable is securely connected to the mouse port (not the
keyboard port) on the rear panel of the server.
If the problem persists, replace the mouse or contact your HP Customer
Support provider.
Error code 0103
HP ProLiant ML110 Server Operations and Maintenance Guide
continued