Hardware Configuration Procedures - HP proliant ML110 Operation And Maintenance Manual

System Configuration
2. Align then insert the two plastic retention clips to their notch on the front panel, then
press them firmly until they snap into place.

Hardware Configuration Procedures

Default Mass Storage Devices
CD-ROM Drive
To Replace the CD-ROM Drive
1. Perform steps 1-3 of the pre-installation instructions.
2. Remove the left-side cover.
3. Remove the front bezel.
4. Remove the currently installed CD-ROM drive from the server:
a. Disconnect the IDE power cable from the rear of the CD-ROM drive.
b. Disconnect the IDE data cable from the rear of the CD-ROM drive.
c. Press the drive-retaining lever.
d. Move the lever downward to release the bar from its retaining hook.
e. Gently pull out the CD-ROM drive from the chassis.
4-6
Figure 4-4: Reinstalling the front bezel
WARNING: To avoid any damage to the system as well as to prevent any bodily harm,
always observe the pre- and post-installation procedures described in this chapter, and
the ESD precautions listed in Appendix B.
HP ProLiant ML110 Server Operations and Maintenance Guide