HP proliant ML110 Operation And Maintenance Manual page 54

•
Diagnostics for Windows
This utility is installed from the Startup CD. For instructions, refer to the README.TXT
file inside the Diagnostics for Windows folder in the Startup CD. Diagnostics for
Windows provides an easy-to-use hardware diagnostic for:
— Server verification
— Rapid troubleshooting
For more information on this diagnostic utility, refer to its accompanying documentation.
•
BIOS Setup Utility
This firmware utility is used to configure the system configuration defaults. Use this
utility to:
— Set default BIOS settings
— Set the system date and time
— Set and clear the system passwords
— Set device boot priority
The Setup Utility used by the HP ProLiant ML110 server is Phoenix BIOS v4.06. For
more information on this utility, refer to Chapter 5.
NOTE: The Setup Utility automatically detects most of the hardware devices you install, but you should
verify that the server has properly recognized the options after you have installed all of the optional
accessories.
•
LSI SCSI Configuration Utility
This firmware utility is used to configure the LSI SCSI card.
Access the utility and perform initial SCSI card configuration:
1. Turn on the monitor and the server.
2. When the HP logo banners on-screen, press Esc to shift to text mode boot.
3. At the LSI SCSI Configuration Utility copyright page, the message prompt below
4.
HP ProLiant ML110 Server Operations and Maintenance Guide
If the server is already turned on, save your data and exit all open applications, then
restart the server.
displays.
<<<Press F8 for configuration options>>>
Press F8 to display the configuration options.
If you fail to press F8 and POST is initialized, you will need to restart the server.
System Configuration
4-29