Section 1. Novell Netware Installation Overview; Section 2. Automated Installation Via The Hp Netserver Navigator Cd; Section 3. Creating The Drivers Diskette And Installing The Ide Cd-Rom Driver - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual

Section 1. Novell NetWare Installation Overview

Installing NetWare on your network server requires two major steps:
Step 1: Preparing the bootable devices (creating a DOS partition, formatting the partition,
installing DOS, and connect the system to a CD-ROM drive.)
Step 2: Install NetWare and the appropriate HP NetServer mass-storage drivers.
Section 2. Automated Installation via the HP NetServer
Navigator CD
An Automated Installation utility is available on your HP NetServer Navigator CD
provided with your HP NetServer that will guide you through the Novell NetWare
installation. This utility will automatically create a DOS partition, format the partition,
install DOS, connect the NetServer to the CD-ROM drive, start the NetWare installation
process and install the appropriate NetServer drivers. To use this utility, first boot your
HP NetServer using the Navigator CD. Once at the NetServer Navigator Main Menu,
select the Configure the Server option. From the NetServer Navigator Mode Selection
for Configuring the Server menu select Guided Setup. Follow the on-screen
instructions to configure your system and install Novell NetWare.
Section 3. Creating the Drivers Diskette and Installing
the IDE CD-ROM Driver
NOTE: Installing NetWare without using the Automated NOS Installation feature
of the HP NetServer Navigator CD requires familiarity with DOS as well as
NetWare. If you are not familiar with these operation systems, please use the
Automated NOS Installation via HP NetServer Navigator CD.
Creating Drivers Diskette
Requirements
• HP NetServer Navigator CD-ROM
• Blank formatted diskettes
To create a DOS/NetWare drivers diskette using the HP NetServer Navigator CD:
1. Boot your HP NetServer using the Navigator CD.
2. When prompted, select the desired operating system. Once the desired operating
system is highlighted select continue.