HP proliant ML110 Operation And Maintenance Manual page 51

System Configuration
System Fan
A new system fan can be installed to allow the server to operate properly in case the default
system fan becomes defective.
To Replace the Default System Fan
1. Perform steps 1 through 3 of the pre-installation instructions.
2. Remove the left-side cover.
3. Remove the default system fan:
a. Disconnect the system fan cable from its power connector (SYSFAN1) on the
b. While supporting the system fan with one hand, push a finger through the middle
c. Slide the system fan upward to disengage the frame tabs from the chassis.
d. Pull the system fan away from the chassis.
4-26
mainboard.
ventilation hole on the rear panel. This will dislodge the fan from the chassis.
WARNING: Be sure to support the system fan with your hands when dislodging it from
the chassis. The fan could fall onto the mainboard or an accessory board causing
damage if not supported.
Figure 4-27: Removing a system fan from the server
HP ProLiant ML110 Server Operations and Maintenance Guide