Manually Rebuilding Array - HIKVISION DS-9608NI-ST User Manual
Hide thumbs
Also See for DS-9608NI-ST:
- Quick start manual (47 pages) ,
- Quick operation manual (42 pages) ,
- User manual (261 pages)
Table of Contents
Advertisement
User Manual of Network Video Recorder
12.2.2 Manually Rebuilding Array
Purpose:
If you do not enable the Auto-rebuild in Firmware Settings interface (Menu>HDD>RAID>Firmware) or the hot
spare disk has not been configured, then you can rebuild the array manually to restore the array when the virtual
disk is in Degraded status.
Steps:
1.
Enter the Array Settings interface. The disk 3 is lost.
Menu > HDD > RAID > Array
2.
Enter the Virtual Disk interface to check the status of the virtual disk. The virtual disk is in Degraded status.
3.
Click Array tab to back to the Array Settings interface and click
At least one available physical disk should exist for rebuilding the array.
4.
Select the available physical disk and click OK button to confirm to rebuild the array.
Figure 12. 17 Array Settings Interface
Figure 12. 18 Virtual Disk Interface
Figure 12. 19 Rebuild Array Interface
192
to configure the array rebuild.
Hide quick links:
Advertisement
Table of Contents
