Table of Contents
Advertisement
User Manual of DS-9600/8600/7700/7600 Series NVR
10.2.2 Manually Rebuilding Array
Purpose:
If you do not enable the Auto-rebuild in Firmware Settings interface (Menu>HDD>RAID>Firmware) or the hot
spare disk has not been configured, then you can rebuild the array manually to restore the array when the virtual
disk is in Degraded status.
Steps:
1.
Enter the Array Settings interface. The disk 3 is lost.
Menu > HDD > RAID > Array
2.
Enter the Virtual Disk interface to check the status of the virtual disk. The virtual disk is in Degraded status.
3.
Click Array tab to back to the Array Settings interface and click
Figure 10. 18 Set Hot Spare Disk Interface
Figure 10. 19 Array Settings Interface
Figure 10. 20 Virtual Disk Interface
to configure the array rebuild.
164
Hide quick links:
Advertisement
Table of Contents
