Configuring Parameters - HIKVISION DS-9608NI-ST User Manual

User Manual of Network Video Recorder

5.1 Configuring Parameters

Purpose:
By configuring the parameters you can define the parameters which affect the image quality, such as the
transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
2. Check the storage mode of the HDD
1) Click Advanced to check the storage mode of the HDD.
2) If the HDD mode is Quota, please set the maximum record capacity and maximum picture capacity.
For detailed information, see Chapter Configuring Quota Mode.
3) If the HDD mode is Group, you should set the HDD group. For detailed information, see Chapter
Configuring HDD Group for Recording and Capture.
Steps:
1. Enter the Record settings interface to configure the recording parameters:
Menu>Record>Parameters
2. Parameters Setting for Recording
Figure 5. 1 HDD- General
Figure 5. 2 HDD- Advanced
Figure 5. 3
Recording Parameters
71