XYZ Printing da Vinci Jr. 1.0 Quick Manual page 11

Note:
The machine can be turned off only when the cooling fan of the print head stops running after the print
is completed. Turning off the power directly may clog the print head.
This section describes how to clean the feed module. After heavy use of printer, if feeding of material becomes
difficult or impossible, please follow these steps.
Preparation of Tools
A. Cleaning brush that comes with the printer
A. Quick Cleaning
1 Use the "UNLOAD FILAMENT" function to loosen and
remove the filament.
B. Standard Cleaning
1 Use the screwdriver to remove the screw and open the
top cover.
3 Use the cleaning brush to scrub the gear; after removing residues of
filament on the gear, you can insert the guide tube and put the cover
back and then enjoy printing again.
HD23F1JS016
B. Screwdriver (T10) for standard cleaning procedure
Clean Instruction
References:
Please refer to
UTILITIES>CLEAN NOZZLE
to remove the blocks out of the print head.
2 Use the cleaning brush to scrub the feed gear back
and forth to remove the chips of filament out of the
gear. Replace the wire after the cleaning is completed.
2
Press the black rubber fixer on top of hole and pull
the guide tube out.
da Vinci
March 2016
P 11