XYZ Printing da Vinci Jr. 1.0 Quick Manual page 10

CALIBRATE
Calibration is enabled for this new extruder module. Please update printer firmware via XYZware before
using the new extruder.
1. Active print bed calibration by selecting "UTILITIES">"CALIBRATE">"YES" on the screen.
2. Press the detection head on the right side of the print head according to the instruction of screen message,
followed by pressing OK.
PRESS DETECTOR
NEXT TO EXTRUDER
[OK] TO CONTINUE
3. Wait for detecting.
4-1A. If "SUCCESS" is shown for the detection
result, and "AUTO LEVEL OFF" is shown on the
third row on the screen, it indicates good platform
levelness. Press "OK" to exit and print.
CALIBRATE
SUCCESS
AUTO LEVEL OFF
[OK] TO RETURN
4-2A. If the detecting result is shown as "FAIL",
press "OK" to go to next page, and press "OK"
again to exit.
CALIBRATE
FAIL
AUTO LEVEL ON
[OK] TO CONTINUE
Note:
1.The dirt on the detection pin and the top of Extruder module will influence detection result. Make sure
that the dirt is cleaned before calibration.
2.If the residues is on the top of the Extruder module, the detection result will be shown as follows.
Clean the dirt before recalibration.
A 0000 0000 0000
B 0000 0000 0000
C 0000 0000 0000
[OK] TO RETURN
3. The printer may enable or disable auto-level based on the result of calibration. You may switch off
the function manually under "Settings".
HD23F1JS016
PLEASE CONTACT
CUSTOMER SERVICE
[OK] TO RETURN
CALIBRATE
4-1B. If you see "AUTO LEVEL ON" under "SUCCESS",
this indicates that the print bed is slightly unleveled.
The printer will adjust the configuration based on the
detecting result automatically while "AUTO LEVEL" is
enabled. The printing mode helps to improve printing
quality with slower printing speed. You may switch off
the function under "Settings".
CALIBRATE
SUCCESS
AUTO LEVEL ON
[OK] TO RETURN
4-2B. And check the detecting result by going to
"INFO"> "LEVELING INFO". Contact customer
service for the issue and provide the details of leveling
information.
A 0317 0320 0313
B 0318 0323 0308
C 0312 0300 0440
[OK] TO RETURN
da Vinci
March 2016
P 10