5
Using the Cutting Unit
Kickstand
Parts needed for this procedure:
1
Cutting unit kickstand
Procedure
Whenever the cutting unit has to be tipped to expose the
bedknife/reel, prop up the rear of the cutting unit with the
kickstand to make sure that the nuts on the back end of the
bedbar adjusting screws are not resting on the work surface
(Figure
16).
g020158
Figure 16
1. Cutting unit kickstand
Secure the kickstand to the chain bracket with the snapper
pin
(Figure
17).
1. Chain bracket
2. Snapper pin
17
Figure 17
3. Cutting unit kickstand