Parking Brake; Diagnostic Light; Fuel Gauge - Toro 03910 Operator's Manual

Traction unit
Hide thumbs Also See for 03910:
Table of Contents

Advertisement

Lower Mow/Raise Control Lever
This lever
(Figure
20) raises and lowers the cutting units and
also starts and stops the cutterheads when the cutterheads
are enabled in the mow mode. The cutting units cannot
be lowered when the mow/transport lever is in the
transport position.
Note: When the cutting units re enabled, the lever does not
have to be held in the forward position while the cutting units
are lowered or raised.
Engine Coolant Temperature Warning
Light
The temperature warning light
coolant temperature is high. The cutting units will disable, if
the traction unit is not stopped and the coolant temperature
rises another 10° F, the engine will kill.
Oil-Pressure Warning Light
The oil-pressure warning light
oil pressure drops below a safe level.
Alternator Light
The alternator light
(Figure
is running. If it is on, the charging system should be checked
and repaired as necessary.
Glow-Plug Indicator
The glow-plug indicator light
glow plugs are operating.

Parking Brake

Whenever the engine is shut off, engage the parking brake
(Figure
20) to prevent accidental movement of the machine.
To engage the parking brake, pull up on the lever. The engine
will stop if you press the traction pedal with the parking brake
engaged.

Diagnostic Light

The diagnostic light
(Figure
system fault be recognized.

Fuel Gauge

The fuel gauge
(Figure
21) registers the amount of fuel in
the tank.
(Figure
20) glows if the engine
(Figure
20) glows if the engine
20) should be off when the engine
(Figure
20) will glow when the
20) will illuminate should a
1. Fuel gauge
Power Point
The power point, located on the outside of the control panel,
is a 12-volt power supply for electronic devices
1. Power point
Reel Speed Control Knob
The reel speed control controls the speed of the cutting units
(Figure
23). The reel speed increases as the knob is turned
counter clockwise. Refer to the reel speed chart decal
31), to determine the proper reel speed.
19
Figure 21
(Figure
Figure 22
22).
(Figure

Advertisement

Table of Contents
loading

This manual is also suitable for:

3550

Table of Contents