Starting And Stopping The Engine - Toro 03910 Operator's Manual

1. To adjust, move the lever sideways to unlock seat
(Figure 30).
2. Slide the seat to the desired position and release lever
to lock in position.
Changing the Seat Suspension
The seat can be adjusted to provide a smooth and comfortable
ride. Position the seat where you are most comfortable.
To adjust it, turn the knob in front either direction to provide
the best comfort (Figure
Changing the Back Position
The back of the seat can be adjusted to provide a comfortable
ride. Position the back of the seat where it is most
comfortable.
To adjust it, turn the knob, under the right-side armrest, in
either direction to provide the best comfort
Changing the Armrest Position
You can adjust the armrests to provide a comfortable ride.
Position the armrests where they are most comfortable.
Raise the armrest and turn the knob, in either direction, to
provide the best comfort
30).
(Figure
(Figure 30).
30).
1. Back rest knob
2. Seat position adjustment
lever
Starting and Stopping the
Engine
You may need to bleed the fuel system if any of the following
situations have occurred (refer to Bleeding the Fuel System):
•
Initial start up of a new engine
•
The engine has ceased running due to lack of fuel.
•
Maintenance has been performed upon the fuel system
components; i.e. filter replaced, etc.
Starting the Engine
1. Be sure that the parking brake is set and the cutting
unit drive switch is in the Disengage position.
2. Remove your foot from the traction pedal and make
sure that the pedal is in the neutral position.
3. Move the throttle lever to the 1/2 throttle position.
4. Insert the key into the switch and rotate it to the
On/Preheat position until the glow-plug indicator light
goes out (approximately 7 seconds); then rotate the key
to the Start position to engage the starter motor.
24
Figure 30
3. Seat suspension knob
4. Armrest adjusting knob