Setting The Reel Speed - Toro 03910 Operator's Manual

Note: Release the key when the engine starts. The key
will move automatically to the On/Run position.
Important: To prevent overheating of the starter
motor, do not engage the starter longer than 15
seconds. After 10 seconds of continuous cranking,
wait 60 seconds before engaging the starter motor
again.
5. When the engine is started for the first time or after an
overhaul of the engine, operate the machine in forward
and reverse for 1 to 2 minutes. Also operate the lift
lever and cutting unit drive switch to be sure of proper
operation of all parts.
Turn the steering wheel to the left and right to check
steering response; then shut the engine off and check
for oil leaks, loose parts, and any other noticeable
malfunctions.
CAUTION
Stop the engine and wait for all moving parts
to stop before checking for oil leaks, loose
parts, and other malfunctions.
Stopping the Engine
Move the throttle control to the Idle position, move the
cutting unit drive switch to Disengage, and rotate the starter
key to Off. Remove the key from the switch to prevent
accidental starting.
1. 8-blade reel adjustment
2. 11-blade reel adjustment
4. To set the reel speed, rotate the knob
until the indicator arrow is in line with the number
designating the desired setting.

Setting the Reel Speed

To achieve a consistent, high quality of cut and a uniform
after cut appearance, it is important that you set the reel speed
controls (located under the seat) correctly. Adjust the reel
speed controls as follows:
1. Select the height of cut at which the cutting units are
2. Choose the desired ground speed best suited for
3. Use the graph on the reel speed chart decal
Figure 31
3. Read the Operator's Manual for information on adjusting the
reel.
(Figure 32)
25
set.
conditions.
to determine the proper reel speed setting.
(Figure 31),