Specifications; Attachments/Accessories; Operation; Checking The Engine-Oil Level - Toro 03910 Operator's Manual

Figure 23
1. Backlap lever
Backlap Lever
Use the backlap lever in conjunction with the lower
mow/raise control lever for the reels

Specifications

Note: Specifications and design are subject to change
without notice.
Width of Cut
Overall Width
Transport Width
Overall Length
Height to top of ROPS
Wheel Base
Weight with 18 inch, 8 blade
cutting units
Weight without cutting units

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
2. Reel speed control knob
(Figure 23).
208 cm (82 inches)
239 cm (94 inches)
231 cm (91 inches)
295 cm (110 inches)
188 cm (74 inches)
151 cm (59.5 inches)
900 kg (1985 lb)
708 kg (1560 lb)

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Checking the Engine-Oil Level

Service Interval: Before each use or daily
The engine is shipped with oil in the crankcase; however, the
oil level must be checked before and after the engine is first
started.
Crankcase capacity is approximately 3.8 L (4 US qt) with
the filter.
Use high-quality engine oil that meets the following
specifications:
•
API Classification Level Required: CH-4, CI-4 or higher.
•
Preferred oil: SAE 15W-40 (above 0ºF (-17ºC))
•
Alternate oil: SAE 10W-30 or 5W-30 (all temperatures)
Note: Toro Premium Engine oil is available from your
distributor in either 15W-40 or 10W-30 viscosity. Refer to the
parts catalog for part numbers.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
sump for at least 10 minutes before checking. If the oil level
is at or below the "add" mark on the dipstick, add oil to bring
the oil level to the "full" mark. Do not overfill the engine. If
the oil level is between the "full" and "add" marks, no oil
addition is required.
1. Position the machine on a level surface.
2. Remove the dipstick
clean rag.
1. Dipstick
3. Push the dipstick down into the dipstick tube and make
sure that it is seated fully. Pull the dipstick out and
check the oil level.
4. If the oil level is low, remove the oil-fill cap
and gradually add small quantities of oil, checking the
20
(Figure 24) and wipe it with a
Figure 24
(Figure 25)