Table of Contents
Advertisement
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Checking the Fuses
The fuses in the electrical system are located under the
control panel.
Drive System
Maintenance
Adjusting the Traction Drive
for Neutral
If the machine moves when the traction pedal is in the neutral
position, adjust the traction cam.
1. Park the machine on a level surface and turn the engine
off.
2. Raise one front wheel and rear wheel off of the floor
and place support blocks under the frame.
WARNING
If the machine is not supported adequately, it
may accidentally fall, injuring anyone under
the machine.
One front wheel and rear wheel must be raised
off of the ground or the machine will move
during adjustment.
3. Loosen the locknut on the traction adjustment cam
(Figure
58).
1. Traction adjustment cam
WARNING
The engine must be running so a final
adjustment of the traction adjustment cam
can be performed. Contact with hot or moving
parts can result in personal injury.
Keep hands, feet, face, and other body parts
away from the muffler, other hot parts of the
engine, and other rotating parts.
4. Start the engine and rotate the cam hex in both
directions to determine the mid position of the neutral
span.
40
Figure 58
2. Locknut
Advertisement
Table of Contents
