Table of Contents
Advertisement
5. Connect the Diagnostic ACE connector to the harness
connector.
Note: Make sure that the correct overlay decal is
positioned on the Diagnostic ACE.
6. Turn the key switch to the On position, but do not
start the machine.
Note: The red text on the overlay decal refers to input
switches and the green text refers to outputs.
7. The "outputs displayed" LED, on lower right column
of Diagnostic ACE, should be illuminated. If the
"inputs displayed" LED is illuminated, press the toggle
button, on the Diagnostic ACE, to change the LED to
"outputs displayed".
Note: It may be necessary to toggle between "inputs
displayed" and "outputs displayed" several times to do
the following step. To toggle back and forth, press
the toggle button once. This may be done as often as
required. Do not hold the button.
8. Sit on the seat and attempt to operate the desired
function of the machine. The appropriate output
LEDs should illuminate to indicate that the ECM is
turning on that function.
Note: If the correct output LEDs do not illuminate,
verify that the required input switches are in the
necessary positions to allow that function to occur.
Verify correct switch function. If the output LEDs are
on as specified, but the machine does not function
properly, this indicates a non-electrical problem. Repair
as necessary.
Note: If each output switch is in the correct position
and functioning correctly, but the output LEDs are not
correctly illuminated, this indicates an ECM problem.
If this occurs, contact your Toro Distributor for
assistance
Important: The Diagnostic ACE display must
not be left connected to the machine. It is not
designed to withstand the environment of the
everyday use of the machine. When you are
finished using the Diagnostic ACE, disconnect
it from the machine and connect the loop-back
connector to the harness connector. The machine
will not operate without the loopback connector
installed on the harness. Store the Diagnostic
ACE in a dry, secure location in the shop, not on
the machine.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions. Knowing this information could
help you, your family, pets, or bystanders avoid injury.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow-moving
vehicle emblem is dangerous and can lead to
accidents causing personal injury.
Do not drive the machine on a public street or
roadway.
To transport the machine:
1. If using a trailer, connect it to the towing vehicle and
connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Stop the engine, remove the key, set the brake, and
close the fuel valve.
5. Use the metal tie-down loops on the machine to
securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes
1. Tie-down loops
Loading the Machine
Use extreme caution when loading the machine onto a trailer
or a truck. One full-width ramp that is wide enough to extend
beyond the front tires of the machine is recommended instead
of individual ramps for each tire
possible to use one full-width ramp, use enough individual
ramps to simulate a full-width continuous ramp.
29
(Figure
38).
Figure 38
(Figure
39). If it is not
Advertisement
Table of Contents
