Table of Contents
Advertisement
14.1.1. DISTRIBUTION BLOWER
To check the status of the distribution blower, go to the main menu under "TROUBLESHOOT LINK" then go to page 5.
When the fan is on, the selected speed is black.
14.1.2. AIR CONTROL DAMPER
To check the status of the air damper, go to the main menu under "TROUBLESHOOT LINK" then go to page 3. When
the furnace is in wood heating, the damper is open. The green square next to "DAMPER" should be on the left, (closed
circuit). When another heating mode is on, the damper is closed, so the circuit is open and the green square is on the
right.
14.1.3. TEMPERATURE PROBE (RTD)
The temperature probe continuously reads the temperature in the plenum and displays it on the main page in the upper
right corner. If the probe fails, the error message "PLENUM OVERTEMP" will appear.
COMBUSTION FAN FUSE
THE COMBUSTION FAN
14.2. MAIN ERROR CODES, POSSIBLE CAUSES AND SOLUTIONS
FUSE BLEW UP
This section contains main error codes, possible causes and many suggestions to guide you in resolving them. To go
RESET
DETAILS
back to the main menu, press the
button.
NOTE: IF, AFTER PERFORMING ALL THE POSSIBLE SOLUTIONS MENTIONED IN THE FOLLOWING SECTION,
YOU ARE STILL EXPERIENCING PROBLEMS WITH YOUR FURNACE, CALL YOUR LOCAL DEALER OR
AFTER-SALE SERVICE.
41
Advertisement
Table of Contents
