Floor Protection - CADDY PF01302 Installation And Operating Instructions Manual

9.7.4. FLOOR PROTECTION

If the floor is made of non combustible material, no
floor protector is required.
If the floor is made of combustible material, a non
combustible material floor protector is required (see
table below).
A
B
C
D
E
*Steel with a minimum thickness of 0.015" (0.38 mm) or ceramic tiles sealed together with grout. No protection is required if the unit
is installed on a non-combustible floor (ex: concrete).
Note 1: The floor protection at the back of the furnace is limited to the furnace's required clearance (A) if such clearance is smaller
than 8 inches (203 mm).
Note 2: Only required under the horizontal section of the flue pipe. Must exceed each side of the flue pipe by at least 2 inches (51
mm).
22
FLOOR PROTECTION*
CANADA
18" (457 mm)
From door opening
N/A (USA only)
8" (203 mm)
8" (203 mm) – Note 1
N/A (USA only)
USA
16" (406 mm)
From door opening
8" (203 mm)
From door opening
N/A (Canada only)
N/A (Canada only)
Note 2