Installing The Heater - Procom EN250TYLA-B Owner's Operation And Installation Manual

1. Install legs and pedestal decorating trim.
Lay the heater down on its back and install the
legs with care on the bottom panel (as shown in
Figure 1). Make sure the vein side is forwards.
Except model EL(N)250TYLB
Install the pedestal decorating trim (front and
side) under the pedestal with screws.
2. Install the decorating logs.
Fasten decorating logs 1 2 3 onto the correspondent angle iron (Figure 4).
Insert the pinhole on the upper part of log 4 into the pin on the left side of log 1. Place the
lower part on the flat roof at the left side of log 3 (Figure 5).
Insert the pinhole on the upper side of log 5 into the pin on the right side of log 1. Place the
lower part on the flat roof at the right side of log 3 (Figure 6).
5. Install the heater according to the Installation in the owner's manual.
Figure 3
Figure 5
20
2 1
Figure 1
Figure 2
Figure 4
Figure 6