Anticorrosion Treatment - Sea-doo 2006 3D RFI Operator's Manual

Remove both spark plugs and spray
XP-S LUBE or an equivalent lubricant
into each cylinder.
To prevent fuel to be injected and also
to cut the ignition at the engine start-
ing, proceed as follows.
While engine is stopped, fully depress
throttle lever and HOLD for cranking.
NOTE: A 1 second beep every second
indicates the drowned mode is active.
Crank the engine a few turns to distrib-
ute the oil on cylinder wall.
Apply anti-seize lubricant on spark plug
threads then reinstall them.
Properly reconnect spark plug cables
to spark plugs.
WARNING
Always reconnect spark plug ca-
bles at the same spark plugs where
they come from.
Wipe off any residual water from the
engine.

Anticorrosion Treatment

To prevent corrosion, spray a corrosion
inhibitor (salt water resistant) such as
XP-S LUBE or an equivalent lubricant
over metallic components in engine
compartment.
Apply dielectric grease (salt water re-
sistant) on battery posts and cable
connectors.
CAUTION: Never leave rags or tools
in the engine compartment or in the
bilge.
_____________________
65