Anticorrosion Treatment; Flushing - Sea-doo Speedster 200 Operator's Manual

Flushing

To flush the exhaust cooling systems,
start each engine then immediately
open the water tap.
WARNING
Certain components in the engine
compartment may be very hot. Di-
rect contact may result in skin burn.
Do not touch any electrical parts or
jet pump area when engine is run-
ning.
CAUTION: Never flush a hot engine.
Always start each engine before
opening the water tap. Open water
tap immediately after each engine is
started to prevent overheating.
Run each engine about 20 seconds at
a fast idle between 4000 - 5000 RPM.
CAUTION: Never run engines with-
out supplying water to the exhaust
cooling systems when boat is out of
water.
Ensure water flows out of jet pumps
while flushing. Otherwise, refer to an
authorized Sea-Doo sport boat dealer
for servicing.
CAUTION: Never run engines longer
than 5 minutes. Drive line seals have
no cooling when the boat is out of
water.
Close the water tap, then stop the en-
gine.
CAUTION: Always close the water tap
before stopping the engine.
Leave all compartments open to air
dry.

Anticorrosion Treatment

To prevent corrosion, spray a corrosion
inhibitor (salt water resistant) such as
BOMBARDIER LUBE lubricant or equiv-
alent over metallic components in en-
gine compartment.
NOTE: Engine fogging should be done
with BOMBARDIER LUBE lubricant
whenever the boat is to be stored for
few days or a long period.
Apply dielectric grease (salt water re-
sistant) on battery posts and cable con-
nectors.
CAUTION: Never leave rags or tools
in the engine compartment or in the
bilge.
73