Pre-Operation Checks - Sea-doo 2006 3D RFI Operator's Manual

PRE-OPERATION CHECKS

The pre-operation check is very important prior to operating the water-
craft. Always check the proper operation of critical controls, safety fea-
tures and mechanical components, before starting as listed hereinafter. If
not done as specified here, severe injury or death might occur. Bring all
safety equipment required by local laws.
Some of the following items may not have been previously covered in this
guide, however they will be described in the MAINTENANCE or SPECIAL
PROCEDURES section. Please refer to these sections to have more detailed
information.
Engine should be off and the safety lanyard should always be removed
from its post prior to verifying any of the following points. Only start wa-
tercraft once all items have been checked and operate properly.
ITEM
Hull
Jet pump water intake
Bilge
Water flow in cooling system
(only when temperature is below
or close to freezing point)
Battery
Fuel tank and oil reservoir
Engine compartment
Steering system
Steering pole
Throttle system
VTS (if so equipped)
Safety lanyard and engine start/stop
button
Optional configurations
NOTE: See the detailed instructions hereinafter.
______________________
50
WARNING
WARNING
OPERATION
Inspect.
Inspect/clean.
Drain. Ensure plugs are secured.
Check if water properly flows out at jet pump.
Inspect tightness of cables and retaining
bracket(s)
Refill.
Check fuel line connections for tightness.
Check for any fuel leak/odor.
Check operation and proper handlebar
position.
Check operation.
Check operation.
Check position and adjustment.
Check operation.
Check installation and settings.
✓