Pre-Operation Checks - Sea-doo GTI Operator's Manual

PRE-OPERATION CHECKS

The pre-operation check is very important prior to operating the water-
craft. Always check the proper operation of critical controls, safety fea-
tures and mechanical components, before starting as listed hereinafter. If
not done as specified here, severe injury or death might occur. Bring all
safety equipment required by local laws.
Some of the following items may not have been previously covered in this
guide, however they will be described in the MAINTENANCE or SPECIAL
PROCEDURES section. Please refer to these sections to have more detailed
information.
Engine should be off and the DESS key should always be removed from
its post prior to verifying any of the following points. Only start watercraft
once all items have been checked and operate properly.
ITEM
Hull
Jet pump water intake
Bilge
Battery
Fuel tank
Engine compartment
Engine oil level
Engine coolant level
Steering system and side
vanes (O.P.A.S.)
Throttle system
Shifter system
VTS (if so equipped)
Storage compartment cover s
and seat
Self-Contained Removable
Storage Bin
Wakeboard(s) and rack(s)
WARNING
WARNING
Inspect.
Inspect/clean.
Drain. Ensure plugs are secured.
Inspect tightness of cables and retaining fasteners.
Refill.
Check fuel line connections for tightness. Verify for any fuel
leak/odor as well as oil and coolant leaks.
Check/refill.
Check/refill.
Check operation.
Check operation.
Check operation.
Check operation.
Ensure they are closed and latched.
Ensure it is installed on vehicle and properly closed and
latched.
– Ensure rack is installed properly.
– Make sure bungee cords are in good condition.
– Ensure wakeboard is installed properly.
_____________________
OPERATION
✓
67