Pre-Operation Checks - Sea-doo ISLANDIA Operator's Manual

PRE-OPERATION CHECKS

The pre-operation check is very important prior to operating the vehicle.
Always check the proper operation of critical controls, safety features and
mechanical components before starting. If not done as specified here, se-
vere injury or death might occur. Bring all safety equipment required by
local laws.
Some of the following items may not have been previously covered in this guide,
however they will be described in the MAINTENANCE or SPECIAL PROCE-
DURES section. Please refer to these portions to have more detailed information.
Prior to operating the craft, verify the following:
Engine should be off and the safety lanyard must always be removed from
its switch prior to verifying any of the following. Only start craft once all
items have been checked and operate properly.
ITEM
Safety lanyard ignition switch
Hull
Jet pump water intake/inlet grate Inspect/clean.
Bilge
Batteries
Main battery cut-off switch
Navigation lights
Fuel tank, potable water tank and
oil reservoir
Engine compartment
Steering
Throttle/shifter system
Bilge blower and bilge pump
Main and fountain water pumps
Mandatory safety boating
equipment
Storage compartment covers and
engine cover
WARNING
WARNING
SUMMARY
OPERATION
Check operation.
Inspect.
Drain. Ensure plug is secured.
Inspect tightness of cables and retaining straps.
Ensure it is in the ON position.
Check operation.
Refill.
Verify fuel/oil system components.
Check operation.
Check operation.
Check operation.
Check operation.
Check operation.
Ensure they are closed and latched.

59