Pre-Operation Checks - Sea-doo Challenger*180 Operator's Manual

PRE-OPERATION CHECKS

The pre-operation check is very important before operating the boat. Al-
ways check the proper operation of critical controls, safety features and
mechanical components before starting. If not done as specified here, se-
vere injury or death might occur. Bring all safety equipment required by
local laws.
Some of the following items may not have been previously covered in this guide,
however they will be described in the MAINTENANCE or SPECIAL PROCE-
DURES section. Please refer to these portions to have more detailed information.
Engine should be off and the safety lanyard must always be removed from
the DESS post before verifying any of the following. Only start boat once
all items have been checked and operate properly.
ITEM
Hull
Jet pump water intake
Bilge
Battery
Main battery cut-off switch
Navigation lights
Fuel reservoir
Engine compartment
Fire extinguisher
Steering
Throttle/shifter system
Bilge blower and bilge pump
Safety lanyard/DESS/engine
start/stop button
Mandatory safety boating
equipment
Storage compartment covers
Sacrificial anodes
Engine oil level
Cooling system coolant level
64
WARNING
WARNING
SUMMARY
OPERATION
Inspect for damage.
Inspect/clean.
Drain. Ensure plugs are secured.
Inspect tightness of cables and retaining straps.
Ensure it is in the ON position.
Check operation.
Refill.
Verify fuel exhaust components.
Inspect condition/mounting.
Check operation.
Check operation.
Check operation.
Check operation.
Check operation.
Ensure they are closed and latched.
Verify condition (replace when 50% corroded).
Refill as needed.
Refill as needed.