Table of Contents
Advertisement
Getting Started
Powering ON the projector
1.
Connect the power cord to the P5.
2.
Connect the other end of the power cord into the wall power source.
3.
Toggle the On / Off switch on the side of the projector to the "ON" position --the
projector should automatically turn on.
4.
If the projector does not automatically turn on with the "Power Switch" toggled to the
"ON" position, press the "ON/OFF POWER"
2-3 seconds to start the projector
Standby Mode
1.
To transition to "STANDBY" mode, press the power button
the remote control.
2.
The optical engine should power off and the fan should stop spinning. The projector
is now in "STANDBY" mode and can be turned on using the remote control.
*Note: Standby mode will still consume a small amount of power.
Powering OFF the projector
1.
To turn off the projector, toggle the "Power Switch" to the "OFF" position. This will
fully turn off the projector.
Chapter 2
button on the keypad and hold for
twice on the keypad or
4
Hide quick links:
Advertisement
Table of Contents
