Chapter 2: Getting Started - AAXA Technologies M7 User Manual

Getting Started
Powering ON the projector
1. Connect the power cord to the M7.
2. Connect the other end of the power cord into the wall power source.
Toggle the On / Off switch on the side of the projector to the "ON" position - the
3.
projector should automatically turn on.
If the projector does not automatically turn on with the "Power Switch" toggled to the
4.
"ON" position, press the "ON/OFF POWER"
projector.
Standby Mode
To transition to "STANDBY" mode, press the power button
1.
The optical engine should power off and the fan should stop spinning. A red LED
2.
light is on indicating that the projector is in Standby Mode. The projector is now in
"STANDBY" mode and can be turned on using the remote control.
*Note: Standby mode will still consume a small amount of power.
Powering OFF the projector
To turn off the projector, toggle the "Power Switch" to the "OFF" position. This will
1.
fully turn off the projector.
Chapter 2
button on the remote to start the
on the remote control.
4