Table of Contents
Advertisement
Getting Started
Powering ON the projector
1.
The P6U should be fully charged before startup.
2.
The P6U charges through the Type C power port found
under "Power Input" next to the carry handle.
3.
Toggle the On / Off switch to "On" and the projector
should automatically turn on.
Standby Mode
1.
To transition to "STANDBY" mode, press the power button on the remote control.
2.
The optical engine should power off and the fan should stop spinning. The projector
is now in "STANDBY" mode and can be turned on using the remote control.
*Note: Standby mode will still consume a small amount of power.
Powering OFF the projector
1.
To turn off the projector, toggle the "Power Switch" to the "OFF" position. This will
fully turn off the projector. The unit can only charge when it is off.
Chapter 2
5
Advertisement
Table of Contents
