Table of Contents
Advertisement
Getting Started
Powering ON the projector
1.
To power-on a fully charged S1, hold down the power button for approximately five
seconds until the projector turns on.
Powering OFF the projector
1.
Press the power button once, then again to confirm.
2.
After a few seconds, the unit should turn off fully.
Charging the projector
1.
To charge your S1, use the power adapter supplied in the box. The LED indicator
on the left side of the unit will light up red to show the projector is receiving power.
Once the projector is fully charged, the LED indicator will turn green.
NOTE: The S1's battery does not charge when it is in operation.
Chapter 2
5
Advertisement
Table of Contents
