Chapter 2: Getting Started - AAXA Technologies P7 User Manual

Getting Started
Powering ON the projector
1. Connect the power cord to the P7.
2. Connect the other end of the power cord into the wall power source.
3. Toggle the On / Off switch on the side of the projector to the "ON" position -- the
projector should automatically turn on.
4. If the projector does not automatically turn on with the "Power Switch" toggled to the
"ON" position, press the "ON/OFF POWER"
2-3 seconds to start the projector.
Standby Mode
1. To transition to "STANDBY" mode, press the power button
remote control.
2. The optical engine should power off and the fan should stop spinning. The projector
is now in "STANDBY" mode and can be turned on using the remote control.
*Note: Standby mode will still consume a small amount of power.
Powering OFF the projector
1. To turn off the projector, toggle the "Power Switch" to the "OFF" position. This will
fully turn off the projector. We recommend charging the projector while projector is
fully turned off.
Chapter 2
button on the keypad and hold for
on the keypad or the
4