Table of Contents
Advertisement
Getting Started
Powering ON the projector
1.
Connect the power cord to the HP3.
2.
Connect the other end of the power cord into the wall power source.
3.
Press the On/Off button at the top of the HP3 for about 3 seconds, wait shortly
and the projector should automatically boot up and turn on. You can also press the
Power On/Off button on the Remote Control to power on the projector.
Standby Mode
1.
To transite to "STANDBY MODE", press the power button on the remote control.
2.
The optical engine should power off and the fan should stop spinning. The projector
is now in "STANDBY MODE" and can be turned on using the remote control.
Powering OFF the projector
1.
To turn off the projector, press the "On/Off" button on the navigation pad on top of
the projector or the remote control.This will fully turn off the projector.
2.
Unplug and disconnect the HP3 from the power source
Chapter 2
4
Advertisement
Table of Contents
