Control Panel; Name Of Parts - Konica Minolta bizhub 367 Quick Start Manual

2.5

Control Panel

2.5 Control Panel
The Keypad KP-101 is equipped on the right side of the Control Panel.
2.5.1

Name of parts

10
No. Name
1 Touch Panel
2 NFC area
3 Access
4 Menu
5 Reset
6 Stop
7 Start
bizhub 367/287/227
9 8
Description
Various screens and messages are displayed. Directly touch the
Touch Panel to configure each setting.
Used to associate this machine with an NFC-compatible mobile ter-
minal. This allows you to set network information of this machine to
a mobile terminal via NFC.
To associate this machine with an NFC-compatible mobile terminal,
you will need to install Mobile for Android on the NFC-compatible
mobile terminal. This machine can be easily registered in Mobile for
Android by holding the mobile terminal with Mobile for Android in-
stalled over the NFC area.
If user authentication or account track is enabled, enter the user
name and password for user authentication or the account name
and password for account track, then press this key to start the use
of this machine. After a target operation is completed, press this key
once again to end the use of this machine.
Press this key to display the main menu.
Press this key to reset all settings, excluding the registered ones,
that you entered using the Control Panel.
Press this key to temporarily stop an active copy, scan, or print job.
Press to start the copy, scan or fax operation.
1
7 6 5
2
2
3
4
2-19