Using The Product - Konica Minolta bizhub 367 Quick Start Manual

1
<Using the product>
Do not modify this product, as a fire, electrical shock, or breakdown
could result. If the product employs a laser, the laser beam source could
cause blindness.
Do not attempt to remove the covers and panels which have been fixed
to the product. Some products have a high-voltage part or a laser beam
source inside that could cause an electrical shock or blindness.
Do not keep using this product, if this product becomes inordinately hot
or emits smoke, or unusual odor or noise. Immediately turn OFF the pow-
er switch, unplug the power cord from the power outlet, and then call
your Technical Representative or your authorized service representative.
If you keep on using it as is, a fire or electrical shock could result.
Do not keep using this product, if this product has been dropped or its
cover damaged. Immediately turn OFF the power switch, unplug the
power cord from the power outlet, and then call your Technical Repre-
sentative or your authorized service representative. If you keep on using
it as is, a fire or electrical shock could result.
Do not use flammable sprays, liquids, or gases inside or near this ma-
chine. Do not clean the inside of this machine using a flammable gas
duster. A fire or explosion could result.
<If an RFID module (limited only to 13.56 MHz) for use in inside-the-ma-
chine proximity communication or electromagnetic induction heating (IH)
technology (limited only to 20.05 kHz to 100 kHz) is being used>
This machine generates a weak magnetic field. If you experience any un-
usual symptoms with your implantable medical equipment (cardiac
pacemaker, etc.) while near the machine, move away from the machine
and see a doctor immediately.
Please call your Technical Representative or your authorized service rep-
resentative if you do not understand the purchased product corresponds
or not.
<If a non-contact IC card reader is being used>
If you use an implantable medical equipment (cardiac pacemaker, etc.),
do not bring the IC card reader close from the implant within 12 cm at all
times. The radio waves may affect implantable medical equipment (car-
diac pacemaker, etc.) operations.
Using this product in a poorly ventilated room for a long time or produc-
ing a large volume of copies or prints may cause the odor of exhaust air
from the machine. Ventilate the room well.
The inside of this product has areas subject to high temperature, which
may cause burns.
When checking the inside of the unit for malfunctions such as a paper
misfeed, do not touch the locations (around the fusing unit, etc.) which
are indicated by a "Caution HOT" caution label. A burn could result.
Unplug the product when you will not use the product for long periods of
time.
1-8
WARNING
CAUTION
Safety information 1.3
bizhub 367/287/227