Display Power; Series Controls - Lighthouse a65 Installation And Operation Instructions Manual

6.1 Display power

Powering the display on
1. Press the POWER button on the display.
2. Select Accept to acknowledge the disclaimer
message.
Powering the display on
1. Press the POWER button.
2. Press the OK button to accept the disclaimer
message.
Powering the display off
1. Press and hold the POWER button until the
countdown reaches zero.
Note: If the POWER button is released before
the countdown reaches zero, the power off is
cancelled.
Standby (PowerSave) mode
In PowerSave mode all functions of the multifunction
display remain active, but the unit is placed into
a low power state. The LED lights around the
Rotary controller will blink once every 1.5 seconds
to indicate that the unit is in PowerSave mode.
PowerSave mode is cancelled by pressing a physical
button or when an alarm event occurs.
Note: To ensure user safety the PowerSave
feature will not be available if:
• any connected radars are switched on
• the multifunction display is providing autopilot
control in a system without a dedicated pilot
head and the autopilot is engaged.
Enabling PowerSave mode
To enable PowerSave mode follow the steps below.
1. Ensure any radars connected to the system are
switched off.
2. Press the POWER button.
The shortcuts menu is displayed.
3. Select PowerSave Mode.
The multifunction displays is now in PowerSave
mode.
4. You can wake the unit from PowerSave mode
at anytime by pressing a physical button on the
multifunction display.
Note: PowerSave mode is automatically cancelled
if an alarm event occurs.
90
6.2 a Series Controls
1
2
Descrip-
tion
1 Touch-
screen
2 Power
3 Card
reader slot
D12367-1
Functions
Touch the screen to operate functions,
including all menu operations.
• Press once to switch the unit ON.
• Once powered on, press the Power
button again to open the shortcuts page
where you can adjust the brightness,
perform a screen capture, access
Powersave mode or access the power
controls of external devices.
• Press and hold to switch the unit OFF.
• If an integrated pilot is engaged, press
and hold to put the autopilot into
STANDBY mode.
MicroSD card reader
• a6x and a7x = 1 x MicroSD card slot
• a9x and a12x = 2 x MicroSD card slots
a Series / c Series / e Series
D12577-1